Open Test Framework  
Installation

Table of Contents

Preparation

The following section describes the installation of the OTF and the necessary components of the installation.

Note: The usage of the latest version is recommended!

Note: Rights for installation software (e.g. administrator rights) must be available!

Note: Set the font size of WIndows to 100% is recommended!

Download

The software can be downloaded from the following locations. For the download an user account is necessary, see Licensing.

  1. License Portal
    Contains the latest released version.
  2. Issue Tracking System
    Contains all versions including hotfix and beta versions.

Note: The 64 bit version is recommended!

Installation

Please install the OTF as follows:

  1. Download and run the latest version of the installation files from our website, see Download above
  2. Close the OTF
  3. Start the installer
  4. Follow the instructions in the installation wizard
  5. Install the supplied diagnostic runtime system if necessary
  6. Start the OTF
  7. Activate the OTF, see Activation
  8. Familiarize yourself with the OTF, see First Steps section

MVCI-Server Installation

Please install the MVCI-Server as follows:

  1. Download and run the latest version of the installation files from our website, see Download above
  2. Close the OTF
  3. Start the installer
  4. Follow the instructions in the installation wizard
  5. Restart the computer!
  6. Start the OTF

Important: Do not mix 32 bit and 64 bit versions! The OTF and the MVCI-Server shall have the same architecture.

MVCI-Server Troubleshooting

if the diagnostic communication does not work as expected, please check the following topics:

  1. Check the Runtime Environment Settings
    Check the filenames and folders. There should be no red icon. If there is a red icon, follow the recommendation inside the tool tip.
  2. Check the DiagCom (ODX Diagnostic Data) settings
    Inside the ComboBox Project the installed ODX databases should be available. If not, then no ODX database exists or the Runtime Environment Settings are wrong.